Brands |
N/A ThermOmegaTech® |
Cold Water Inlet |
N/A 1 in |
Drain Connection |
N/A 1-1/4 in |
Weight |
N/A 1.5 lb0.7 kg |
Flow Coefficient (Cv) |
N/A 4.0 |
Maximum Inlet Water Pressure |
N/A 125 psig8.6 bar |
Maximum Temperature |
N/A 250 ºF121 ºC |
Temperature Setpoint |
N/A 125 ºF51.7 ºC |
Thread Type |
N/A National Pipe Thread (NPT) |
Valve Body Material |
N/A Stainless Steel (SS) |
Thermal Actuator Material |
N/A 300 Series Stainless Steel (SS) |
Operating Spring Material |
N/A 300 Series Stainless Steel (SS) |
Ram-Type Plug Material |
N/A 300 Series Stainless Steel (SS) |
Seat Seal Material |
N/A Polytetrafluoroethylene (PTFE) |
Piston Material |
N/A 300 Series Stainless Steel (SS) |
Benefits |
N/A
|
Design Features |
N/A
|
Applications |
N/A
The DTV can be used in applications where a high temperature discharge flow to a drain/sewer must be tempered with cold water. Examples:
|
Operation |
N/A
The DTV is installed into the drain line such that the hot effluent passes over the thermal actuator of the DTV and this thermal actuator controls the cold water inlet port. If the hot effluent is above the specified set-point, the DTV opens to allow injection of cold water. As the hot effluent cools, the DTV automatically modulates to reduce the cold water inlet fl ow. At 10 ºF below the full open temperature, the cold water inlet is fully closed to conserve water. Since the DTV is open only when the effluent exceeds the specified set-point temperature, it conserves water by automatically turning off cold water when not needed. |
Note |
N/A
|